|
|
Local News
|
|
| |
ADVERTISEMENT
|
| |
 |
| CONTACT THE HERALD |
Robert Frank, City Editor
frank@heraldnet.com |
| |
Published: Monday, October 12, 2009
Troopers can’t stop every bad driver
By Bill Sheets Herald Writer
Bill Downing of Everett asks: Recently I was northbound on I-5 past Quil Ceda Village when a car with British Columbia plates was weaving in and out of the 60 mph traffic, going at least 70. The driver was giving no signals, just darting and sliding, including past a state trooper who did not stop the car.
Is there some reason why the Washington State Patrol cannot or will not stop speeding B.C. drivers? In Washington state, apparently having a Canadian plate is better than a diplomatic one as far as carte blanche in traffic is concerned.
State Patrol trooper Keith Leary responds: The Washington State Patrol does not single out any specific drivers or vehicles to pull over. If a trooper observes a vehicle committing a traffic violation, the trooper has the discretion to stop that vehicle. If a driver from another state or country is stopped in the state for a traffic violation, that person is subject to same fines as a Washington resident.
When a violation is identified, troopers take appropriate action. However, troopers are not able to catch every violator. Aggressive driving is one of the top four collision-causing violations, and the State Patrol takes these violations seriously.
From Jan. 1 to Aug. 31 this year, troopers contacted 5,745 aggressive drivers statewide. Troopers drive marked and unmarked patrol cars and motorcycles, and some troopers are assigned specifically to spotting aggressive drivers. Also, WSP aircraft work Snohomish County routinely. The State Patrol suggests that if drivers see aggressive or dangerous actions, and if it is safe to do so, they dial 911 on their cell phone and report the driving behavior. Troopers must observe traffic violations to make a legal stop for the violation.
Kelly Roark of Everett asks: I am a motorcycle rider and several times over the summer I was surprised by grooved pavement on I-5 northbound in Snohomish County. If you’ve never had this experience before, then consider yourself fortunate. Once you’re on grooved pavement at 60 mph, you can’t safely change lanes. Instead, you need to “ride it out” until grooved pavement ends in your lane.
A simple suggestion: One mile ahead of the grooved pavement, post a sign indicating “grooved pavement ahead” and also indicate which lane is grooved. I’ll guarantee you every bike rider will heed that warning.
Meghan Pembroke, a spokeswoman for the state Department of Transportation, responds: We already use advance warning signs to remind drivers to use caution on grooved, ground-down pavement. Our traffic control plans require contractors to place “Grooved Pavement” warning signs 3,000 feet in advance of a work zone and “Motorcycles Use Extreme Caution” signs 1,500 feet ahead. Our project inspectors regularly review traffic control setups in the field to ensure that we are providing adequate warning for drivers. We encourage all drivers to slow down, stay alert and use caution as they approach and drive through any of our work zones.
E-mail Street Smarts at stsmarts@heraldnet.com. Please include your city of residence.
|
| 2
- Top 10 Stories Most Talked about |
| 3
- Top 10 Stories Most Emailed |
|
|
|
|
|